Views: 0 Author: Site Editor Publish Time: 2026-11-20 Origin: Site
Reducing fiber coating diameter from 250μm to 200μm cuts single-fiber cross-section by ~36%. In a 144-fiber air-blown cable, this accumulates into a meaningful OD reduction: 200μm G.657A1 fiber enables a 144-fiber cable to reach approximately 5.7mm outer diameter, versus typically over 7mm with 250μm fiber.
Why G.657A1 matters: Smaller OD must not come at the cost of bend performance. G.657A1 maintains low macrobend loss at tight radii, so the dense cable structure does not compromise reliability. 200μm solves fit; G.657A1 ensures performance.
Engineering value: A ~5.7mm cable fits microducts with ~10mm inner diameter. Compared with larger 144-fiber designs, it leaves more duct space for additional cables or future capacity, and its lower weight supports longer air-blown installation distances.
Selection notes: Confirm bend consistency across fiber batches at 1550/1625nm, sheath friction characteristics for blowing distance, and the specific cable construction (layer-stranded vs. central-tube) behind the 5.7mm figure.
Bottom line: 144 fibers, 200μm G.657A1, 5.7mm OD — a commercially viable combination for high-density air-blown deployment where duct space is the constraint.